Contec Medical Systems Co. Ltd. CMS50EW Manual De Usuario
15
months when it is no regular used. It can extend the battery life following this guidance.
D.Users are advised to calibrate the device termly (or according to the calibrating program of
hospital). It also can be performed at the state-appointed agent or just contact us for calibration.
D.Users are advised to calibrate the device termly (or according to the calibrating program of
hospital). It also can be performed at the state-appointed agent or just contact us for calibration.
7.3. Transportation and storage
A. The packed device can be transported by ordinary conveyance or according to transport contract.
The device can not be transported mixed with toxic, harmful, corrosive material.
B. The packed device should be stored in room with no corrosive gases and good ventilation.
Temperature: -40°C~60°C; Relative Humidity: ≤95%
The device can not be transported mixed with toxic, harmful, corrosive material.
B. The packed device should be stored in room with no corrosive gases and good ventilation.
Temperature: -40°C~60°C; Relative Humidity: ≤95%
8. Troubleshooting
Trouble
Possible Reason
Solution
The SpO
2
and Pulse
Rate can not be
displayed normally
1. The finger is not properly positioned.
2. The patient’s SpO
2. The patient’s SpO
2
is too low to be
detected.
1. Lay the finger properly and try
again.
2. Try again; Go to a hospital for
a diagnosis if you are sure the
device works all right.
again.
2. Try again; Go to a hospital for
a diagnosis if you are sure the
device works all right.
The SpO
2
and Pulse
Rate are not
displayed stably
1. The finger is not laid inside deep
enough.
2. The finger is shaking or the patient is
moving.
enough.
2. The finger is shaking or the patient is
moving.
1. Lay the finger properly and try
again.
2. Let the patient keep calm
again.
2. Let the patient keep calm
The device can not
be turned on
1. The batteries are drained or almost
drained.
2. The device’s malfunction
drained.
2. The device’s malfunction
1.Please recharge the battery
2. Please contact the local
service center.
2. Please contact the local
service center.
The display is off
suddenly
1. This device is set to be automatically
power off within 5 seconds when it cannot
detect any signal (without external probe)
2. The battery is drained away or almost
drained away .
power off within 5 seconds when it cannot
detect any signal (without external probe)
2. The battery is drained away or almost
drained away .
1.Normal
2.Please recharge the battery
2.Please recharge the battery
The battery can not
be full charged even
after 10 hours
charging time.
The battery is broken
Please contact the local service
center.
center.
9. Key of Symbols
Signal Description
Refer to instruction manual/booklet