BW Broadcast Ltd TX300V2 Manual De Usuario
TX V2 FM Broadcast Transmitter
Basic Setup
10
Basic Setup
Quick Start
N.B. Never power on an FM transmitter without a suitable antenna or dummy load connected. The V2
Transmitter's protection circuitry will prevent any internal damage, but it is not advisable to run an FM
transmitter without a load connected.
Transmitter's protection circuitry will prevent any internal damage, but it is not advisable to run an FM
transmitter without a load connected.
Setting up a V2 Transmitter couldn't be any easier. First connect either analogue audio to the left and right back
panel connectors (10&11), digital audio AES/EBU into the left hand connector (10) or feed the MPX input (13)
from an audio processor. Connect the RF output (18) to a 50Ω antenna of the correct power handling capability.
panel connectors (10&11), digital audio AES/EBU into the left hand connector (10) or feed the MPX input (13)
from an audio processor. Connect the RF output (18) to a 50Ω antenna of the correct power handling capability.
The transmitter's frequency and power are both set from the RF Settings menu:
Input selection, pre-emphasis, processing and the stereo parameters are set in the audio settings menu:
Input
Selects analog or digital input to the transmitter's built in stereo encoder/audio processor. For analog,
connect to left and right XLR Inputs. For digital, connect an AES/EBU connection to the left hand XLR
input.
Pre emphasis
Sets pre emphasis to off, 50µS (Europe/Japan) or 75µs (Americas).
Processing Preset
Selects the processing preset on the integrated 4-band DSPX audio processor.
Encoder
Selects the stereo generator mode, from either: Stereo, Mono L+R, Mono L, Mono R and Swap L + R.
MPX Source
Selects if the MPX source for the exciter is internal or external. If using the V2 transmitter with no
external equipment (RDS, audio processor etc) then set to internal. If using any external equipment
set to external. When set to internal, the MPX In and MPX Out connectors are internally connected.
which routes the internal stereo generator directly to the exciter. When set to external, the internal
stereo generator and audio processor is still functioning, but the MPX in and MPX out connections are
not internally connected, allowing MPX signals to be routed to and/or from external equipment.
TX V2
►
►
RF Settings
►
Audio Settings
►
Triggers
►
Alarms
►
System
TX V2►Audio Settings
MPX Source
MPX Source
Internal
Audio Input
Digital
Processing Preset
Talk
Pre-emphasis 75uS
TX V2
►
►
RF Settings
►
Audio Settings
►
Triggers
►
Alarms
►
System
TX V2►RF Settings
Frequency
Frequency
100.00MHz
Power 25W
MPX Source
MPX Source
Internal
FSK On
FSK ID
FSK ID
ABCD
RF Out
(18)
MPX In
(13)
MPX
Out (14)
V2 Transmitter
Audio In
(10 / 11)
(10 / 11)