BW Broadcast Ltd TX50V2 Manual De Usuario
7
Installation
7.1
Quick Start
N.B. Never power on an FM transmitter without a suitable antenna or dummy load connected.
The V2 Transmitter’s protection circuitry will prevent any internal damage, but it is not advis-
able to run an FM transmitter without a load connected.
The V2 Transmitter’s protection circuitry will prevent any internal damage, but it is not advis-
able to run an FM transmitter without a load connected.
Setting up a V2 Transmitter couldn’t be any easier. First connect either analogue audio to
the left and right back panel connectors (10 and 11), digital audio AES/EBU into the left hand
connector (10) or feed the MPX input (13) from an audio processor. Connect the RF output
(18) to a 50Ohm antenna of the correct power handling capability. Connect the required
remote control / monitoring ports (Ethernet, RS232, Alarms/Triggers Port).
the left and right back panel connectors (10 and 11), digital audio AES/EBU into the left hand
connector (10) or feed the MPX input (13) from an audio processor. Connect the RF output
(18) to a 50Ohm antenna of the correct power handling capability. Connect the required
remote control / monitoring ports (Ethernet, RS232, Alarms/Triggers Port).
The transmitter’s frequency and power are both set from the RF Settings menu:
Input selection, pre-emphasis, processing and the stereo parameters are set in the audio set-
tings menu:
tings menu:
Input Selects analog or digital input to the transmitter’s built in stereo encoder/audio proces-
sor. For analog, connect to left and right XLR Inputs. For digital, connect an AES/EBU connec-
tion to the left hand XLR input.
sor. For analog, connect to left and right XLR Inputs. For digital, connect an AES/EBU connec-
tion to the left hand XLR input.
Pre emphasis Sets pre emphasis to off, 50µS (Europe/Japan) or 75µs (Americas).
Processing Preset Selects the processing preset on the integrated 4-band DSPX audio proces-
sor.
sor.
26