BW Broadcast Ltd TX50V2 Manual De Usuario

UDP

A Enable Enables/disables logging messages to a remote UDP logging/syslog server.

B IP Sets the IP address where the log messages should be sent via UDP. This parameter

accepts IPv4 addresses in the form aaa.bbb.ccc.ddd.

C Port Sets the port where the log messages should be sent via UDP. Disable UDP to

change. This parameter accepts values from 1 to 10000.

9.5.16

Diagnostics

This set of parameters report the state of various parts of the system upon boot (OK or fail). If
an error condition is observed, the unit should be re-booted and these parameters should be
examined. This information will be useful when contacting support.

DSPX Comm

This read only parameter reports communication failure with DSPX chip (OK/FAIL). Restart the
unit to refresh this value in case of failure.

Exciter Comm

This read only parameter reports communication failure with AIO exciter chip (OK/FAIL).
Restart the unit to refresh this value in case of failure.

Alarms DAC Comm

This read only parameter reports communication failure with Alarms DAC chip (OK/FAIL).
Restart the unit to refresh this value in case of failure.

Power DAC Comm

This read only parameter reports communication failure with Power DAC chip (OK/FAIL).
Restart the unit to refresh this value in case of failure.

9.5.17

About

Product ID

This read only parameter displays the product ID.