EMW Co. Ltd BHA-WN400 Manual De Usuario
48
6.2. GENERAL
1. Access Port: Select “0001 ~ 9999”
Enter the port number the client uses to communicate with the NVR over the internet.
The default port is 7000. It is recommended to use a port above 1000.
The default port is 7000. It is recommended to use a port above 1000.
2. Bandwidth: Select the network bandwidth to limit the amount of network resources
allocated to client connection. The default is unlimited: “
4 KBPS ~ 8 MBPS”
3. Access Block 1) Ping Block: No response to ping. By default OFF.
2) Scan Block: No response to Auto Scan from EMS. By default OFF.
4. Access Host and Host List: Allows you to access or deny specific IP address.
To allow or deny remote access requires you to enter a range of IP addresses as an
IP address and mask. Host List will be activated when you select deny or allowed.
IP address and mask. Host List will be activated when you select deny or allowed.
5. Auto Port FWD:
Select the ADD button to automatically open ports for Router
communication with UPNP compliance.
6. 2 Way Audio: Support 2 way Audio between NVR and Remote Software