Quanzhou Leixen Electronics Co. Ltd 898UV Manual De Usuario
34
specific transceiver. The PTT ID code is defined in the
programming software; the default ID is “123”.
You can also set whether PTT ID’s are spoken or
displayed. If voice is selected, ID’s of up to five digits
will be spoken. However, up to 14 digit ID’s can be
displayed if voice ID’s are disabled.
Each channel stores whether the PTT ID is enabled.
To enable PTT ID:
In VFO / MR mode, choose the frequency or channel
on which you would like to enable the PTT ID.
Set Menu 31 to ON if you would like to enable the
PTT ID, or OFF to disable it.
Note:
a) In CH Mode, you may not modify this setting.
b) In MR mode, each memory channel can be
programming software; the default ID is “123”.
You can also set whether PTT ID’s are spoken or
displayed. If voice is selected, ID’s of up to five digits
will be spoken. However, up to 14 digit ID’s can be
displayed if voice ID’s are disabled.
Each channel stores whether the PTT ID is enabled.
To enable PTT ID:
In VFO / MR mode, choose the frequency or channel
on which you would like to enable the PTT ID.
Set Menu 31 to ON if you would like to enable the
PTT ID, or OFF to disable it.
Note:
a) In CH Mode, you may not modify this setting.
b) In MR mode, each memory channel can be
individually programmed to enable or disable PTT
ID.
ID.
You may also use the programming software to enable
or disable PTT ID for any channel.
or disable PTT ID for any channel.
The PTT ID can be sent:
1. At the beginning of the transmission: The ID is sent
1. At the beginning of the transmission: The ID is sent
immediately when the PTT key is pressed.
2. At the end of the transmission: the PTT ID is sent
when the PTT key is released.
3. Both: the PTT ID is sent both when the PTT key is
pressed and again when it is released.