Invenco Group Ltd G6OPT Manual De Usuario
DCV-00001 Rev 05 S2 G6 OPT Installation Guide
Page 21
Step Description
Photo reference
1.
Ensure the paper roll has a neat cut edge.
2.
Remove spindle from the paper holder
position
Insert roll in place
position
Insert roll in place
– the paper tension flap
is spring-loaded so you will need to apply
some pressure.
Insert the spindle through the middle of the
roll to hold in place.
some pressure.
Insert the spindle through the middle of the
roll to hold in place.
3.
Insert the cut edge of the paper into the
slot as shown in the photo opposite.
Note: Insert until the printer grips and
Note: Insert until the printer grips and
feeds automatically.
4.
The photo opposite shows the paper
loaded.
loaded.
5.
The photo opposite shows the feed button.
Press either button
to move
the paper forward or back.
Press both buttons together to cut the
paper.
Press both buttons together to cut the
paper.
6.
Feed the paper through the terminal until it
appears out the chute.
Cut the paper using both feed buttons, and
remove the cut length from the chute.
Cut the paper using both feed buttons, and
remove the cut length from the chute.