Invenco Group Ltd G6OPT Manual De Usuario
DCV-00001 Rev 05 S2 G6 OPT Installation Guide
Page 8
2.19
Important Radio, FCC and Interference Information
Changes or modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment.
As stated on the device: This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation.
The G6 OPT device is an FCC Class A device that complies with the Class B limits
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
receiver is connected.
2.20
RF Exposure information
Versions of this device have contactless card reading circuitry that transmits electromagnetic
waves. The energy from this circuitry is mostly a magnetic filed. The power output of this
transmitter is much less than 200mW threshold for any SAR risk and is therefore exempt from
SAR evaluation and considered to be safe to use in normal operation.
To further minimise any risk of exposure it is recommended that the device be installed such
that there no obstructions that would prevent a user from having a minimum 20cm clearance
between their head and the contactless symbol displayed on the device when the user is in
the process of presenting a contactless payment card to the device.
waves. The energy from this circuitry is mostly a magnetic filed. The power output of this
transmitter is much less than 200mW threshold for any SAR risk and is therefore exempt from
SAR evaluation and considered to be safe to use in normal operation.
To further minimise any risk of exposure it is recommended that the device be installed such
that there no obstructions that would prevent a user from having a minimum 20cm clearance
between their head and the contactless symbol displayed on the device when the user is in
the process of presenting a contactless payment card to the device.
2.21
Laser Warning
Some models of the G6 OPT incorporate a barcode reader. The barcode reader incorporates
a laser aiming system. The Laser has a Class 2 output power to IEC 60825-1:2007:
a laser aiming system. The Laser has a Class 2 output power to IEC 60825-1:2007:
CAUTION
LASER RADIATION
DO NOT STARE INTO BEAM
1mW MAX OUTPUT at 635-670nm
CLASS 2 LASER PRODUCT