Yuneec Technology Co. Limited ST10 Manual De Usuario
2
Features
IMPORTANT NOTE: This Quick Start Guide is NOT intended to replace
the complete content included in the ST10 instruction manual. Although
the following information covers some of the basic details you need to
know we strongly recommend reading through the instruction manual
completely before charging/using the ST10.
Charging Your ST10
Use a suitable power source/supply (1.0A and 5V MAX output) and a cable with a Micro
USB connector to charge the 3.6V Li-Ion battery installed in the ST10. The time it takes to
fully charge the battery will depend on the current voltage/charge state of the battery and
the charge rate of your chosen power source/supply. For reference it will typically take
approximately 6 hours to charge a near fully discharged battery at the maximum
recommended charge rate of 1.5 amps.
1. Connect the cable with the Micro USB connector to the suitable power
source/supply
2. Connect the Micro USB connector to the corresponding port on the bottom of the
ST10
You can also remove the battery from the back of the ST10 and charge it separately using
a suitable Li-Ion battery charger and a lead with a compatible 2-pin JST connector (at a
maximum recommended charge rate of 1.5 amps).
IMPORTANT NOTE: Charging the Li-Ion battery using an incompatible charger
(such as a NiCd or NiMH battery charger), or even a compatible battery charger with
the incorrect settings, may result in damage to the battery or even fire resulting in
property damage and/or personal injury.