Vubiq Networks Inc. V10G-L Manual De Usuario
24
Vubiq HaulPass V10g User Manual
© 2018 Vubiq Networks, Inc. All Rights Reserved
Changing the Address via the CLI
Use telnet to log in to the terminal with an account that has administrative privileges.
# configure terminal
(config)# interface vlan 1
(config-if-vlan)# ip address 192.168.66.4 255.255.255.0
(config-if-vlan)#
(config)# interface vlan 1
(config-if-vlan)# ip address 192.168.66.4 255.255.255.0
(config-if-vlan)#
At this point you will lose your connection to the terminal and must log in again at the new IPv4 address to save the
running-config to the startup-config.
running-config to the startup-config.
# copy running-config startup-config
Building configuration...
% Saving 1392 bytes to flash:startup-config
#
Building configuration...
% Saving 1392 bytes to flash:startup-config
#
5.3 Using the 48VDC Power Port
Connect the supplied 48VDC connector as shown in Figure 11 below.
Figure 11. Connecting the 48VDC Power Port