Shenzhen KVD Communication Equipment X10 Manual De Usuario
User Manual
46
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could
void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could
void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Specific Absorption Rate (SAR) Information
SAR tests are conducted using standard operating positions accepted by the FCC with the Phone
transmitting at its highest certified power level in all tested frequency bands, although the SAR is
determined at the highest certified power level, the actual SAR level of the phone While operating can
be well below the maximum value, in general, the closer you are to a Wireless base station antenna, the
lower the power output. Before a new model phone is an available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, Tests
for each the FCC that it does not exceed the exposure limit established by the FCC, Tests for each
required by the FCC. The maximum SAR value is 0.867W/Kg.
determined at the highest certified power level, the actual SAR level of the phone While operating can
be well below the maximum value, in general, the closer you are to a Wireless base station antenna, the
lower the power output. Before a new model phone is an available for sale to the public, it must be
tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, Tests
for each the FCC that it does not exceed the exposure limit established by the FCC, Tests for each
required by the FCC. The maximum SAR value is 0.867W/Kg.
For body worn operation, this model phone has been tested and meets the FCC RF exposure
guidelines when used with an accessory designated for this product or when used with an accessory that
contains no metal and that positions the handset a minimum of 10 mm from the body. Non-compliance
with the above restrictions
FCC ID:2ADTE-X10
contains no metal and that positions the handset a minimum of 10 mm from the body. Non-compliance
with the above restrictions
FCC ID:2ADTE-X10