Shenzhen Baicheng Innovation Technology Co. Ltd BCPTA Manual De Usuario
PLUTO TRIGGER
BAICHENG INNOVATIONS
25
duration now becomes the actual exposure time. The main advantage of the
flash method is the exposure speed and better timing consistency. Electronic
flashes are capable of light strobes with durations of 1/10,000 or faster (lower the
power setting of the flash, the shorter the flash duration).
flash method is the exposure speed and better timing consistency. Electronic
flashes are capable of light strobes with durations of 1/10,000 or faster (lower the
power setting of the flash, the shorter the flash duration).
The lag between the trigger and the flash strobe is insignificant. The disadvantage
of this method is that the picture needs to be taken in a dark room to avoid the
over exposure. Also since the flash is used to make the exposure, it may be more
difficult to provide a uniform lighting or to illuminate the background.
of this method is that the picture needs to be taken in a dark room to avoid the
over exposure. Also since the flash is used to make the exposure, it may be more
difficult to provide a uniform lighting or to illuminate the background.
5.1.
L
ASER MODE
Caution
:
Laser beam is dangerous. Avoid eye contact. Use the laser source at
your own risk.
Usage
1. Connect Pluto Trigger to your camera with shutter release cable.
2. Turn on Pluto Trigger and make sure Bluetooth is turned on.
3. Turn on your camera. Set your camera to Manual exposure mode.
4. Disable automatic focusing on your camera. You may also need to set it to
Single drive mode. Quiet or Silent mode is also acceptable, if available on
your camera.
your camera.
5. Start Pluto Trigger app on your phone; connect to Pluto Trigger with Bluetooth;
switch to “Laser” mode.
6. Point you laser beam on to the laser sensor on front side of Pluto Trigger (the
transparent led). Check the sensor value in the app to make sure laser is
aligned.
aligned.
7. Adjust the “sensitivity” setting using the slider. Make sure the sensor value is
greater than the threshold (middle of the arc) when laser beam is feed to the
laser sensor. And also make sure the sensor value is smaller than the threshold
when you break the laser beam.
laser sensor. And also make sure the sensor value is smaller than the threshold
when you break the laser beam.