Doodle Labs Pte Ltd DLM168N Manual De Usuario

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment. 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment   generates   uses   and   can   radiate   radio   frequency   energy   and,   if   not   installed   and   used   in   accordance   with   the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna. 
-- Increase the separation between the equipment and receiver. 

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
-- Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not 
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause 
undesired operation

150 Kampong Ampat

2 Mattawang Drive

KA Center, Suite 05-03

Somerset, NJ 08873

Singapore 368324

Tel: +1 862 345 6781

Tel:  +65 6253 0100

Fax: +65 6353 5564

 

 

The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons 

and must not be collocated or operating in conjunction with any other antenna or transmitter, except in accordance with

 FCC multi-transmitter product procedures.

Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co

l

located or operating in conjunction with any other antenna or transmitter.

The availability of some specific channels and/or operational frequency bands are country dependent and are
 firmware programmed at the factory to match the intended destination.
The firmware setting is not accessible by the end user.

The modular can be installed or integrated in mobile or fix devices only. 

This modular cannot be installed in any portable device, for example, USB dongle like transmitters is forbidden.

If the FCC identification number is not visible when the module is installed inside another device, then the outside

 of the device into which the module is installed must also display a label referring to the enclosed module. 

This exterior label can use wording such as the following: “Contains Transmitter Module  FCC ID:2AG87DLM168N 

Or Contains FCC ID:2AG87DLM168N” when the module is installed inside another device, the user manual

 of this device must contain below warning statements; 

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 

(1) This device may not cause harmful interference. 
(2) This device must accept any interference received, including interference that may cause undesired operation. 

2. Changes or modifications not expressly approved by the party responsible for compliance could void the

 user's authority to operate the equipment. 

The devices must be installed and used in strict accordance with the manufacturer's instructions as

 described in the user documentation that comes with the product.

The antenna type used is the reverse screw R-SMA antenna and the max antenna gain is 3dBi.

The diagram shows how to connect the modular with its intended antenna .

Modular

Coaxial Line

(50   )

Ω

Antenna