Camden Door Control TXLF Manual De Usuario

Installation Instructions 

Page 1 of 2

Camden Lazerpoint™ Radio Controls comprise the following 

models:
•  CM-TXLF-1, CM-TXLF-2, & CM-TXLF-4 Key Fob 

Transmitters, as well as;

•  CM-TX-9 Wall switch ready transmitter
•  CM-TX-99 Plug-in 2-Channel Transmitter
•  CM-RX-91 Basic Receiver
•  CM-RX-92 Full function (dual relay) Receiver.
These instructions cover the TXLF transmitters.
Camden Key Fob transmitters utilize readily available 

 

CR-2032 Lithium batteries, and special circuitry to assure 

long life. A proprietary bi-colour LED circuit is used to 

annunciate wireless activation, low battery, & Battery Gas 

Gauge™ conditions.

Mounting
Camden TXLF Fobs can be attached to a key chain using the 

included ring.
Fobs can also be mounted to a wheelchair by using accessory 

number # CM-TXLFB Mounting Base. This unique accessory 

converts any of the Mini Fobs to a full size unit which may be 

clipped to a belt or sun-visor, or fastened to a desk or counter 

for reception use. See our Lazerpoint™ spec sheet or TXLFB 

Instruction manual for further details.
The CR-2032 battery is pre-installed in the Fob. Simply press 

the button and observe the GREEN LED, which indicates 

proper transmission.
Test the battery strength by pressing and holding the button 

for  approximately  5  seconds.  The  LED  should  flash  RED  

5 times, meaning the battery is at full capacity. This is the 

Battery Gas Gauge™ feature. If the LED flashes RED only 1 - 2 

times, you should change the battery for a fresh (new) one. 

See instructions at right.
When the battery is low and needs to be changed, the LED 

will indicate a slow red flash — 1 flash per second. The unit will 

still continue to function (transmit) for a time, but the battery 

should be changed as soon as possible.

Learning the Transmitter(s) to the Receiver
To learn the transmitter into an RX-91 or RX-92 receiver, press 

the PB1 (or PB2) button on the Receiver using a small blunt 

object such as a small blade screwdriver or similar. Within  

10 seconds, press the button on the TXLF transmitter. The 

Green LED Array will flash once to confirm enrollment. Repeat  

with any additional transmitters. Pressing the learned transmitter 

again will signal the receiver that you are finished programming 

and  LED’s  1  &  2  will  flash,  in  an  alternating  sequence. 

Pressing the transmitter a third time will activate the relay 

and corresponding LED, and also the device connected to the  

relay contacts.
For multiple button FOBS – TXLF-2 & TXLF-4, learn the desired 

button into one receiver, and the other button(s) into additional 

receivers.  (You could also learn Button 1 into Channel 1 of the 

RX-92, and Button 2 into Channel 2 of the same RX-92.)
Refer to the RX-91 or RX-92 receiver for further programming 

instructions.

Camden

PW

A-201-0329-051

Camden

PW

A-201-0329-051

Camden

PW

A-201-0329-051

+

Panasonic

CR2032

3V

+

Camden

PW

A-201-0329-051

Panasonic

CR2032

3V

+