Zero Energy Solutions LTD. CC2530 Manual De Usuario

TYWE1S DATASHEET 

 

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance 

could void the user's authority to operate this equipment. 

This device complies with Part 15 of the FCC Rules. 

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) 

this device must accept any interference received, including interference that may cause undesired operation. 

This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or 

transmitter. 

15.105 Information to the user. 

(b) For a Class B digital device or peripheral, the instructions furnished the user shall include the following or 

similar statement, placed in a prominent location in the text of the manual: 

Note: This equipment has been tested and found to comply 

with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against harmful interference in a residential 

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used 

in accordance with the instructions, may cause harmful interference to radio communications. However, there is 

no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 

interference to radio or television reception, which can be determined by turning the equipment off and on, the 

user is encouraged to try to correct the interference by one or more of the following measures: 

—Reorient or relocate the receiving antenna. 

—Increase the separation between the equipment and receiver. 

—Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected. 

—Consult the dealer or an experienced radio/TV technician for help. 

 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. 

 This equipment should be installed and operated with minimum distance 20cm between the radiator 

 and your body. 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. 

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

The availability of some specific channels and/or operational frequency bands are country dependent and are 

firmware programmed at the factory to match the intended destination. 

The firmware setting is not accessible by the end user. 

The final end product must be labelled in a visible area with the following: 

“Contains Transmitter Module 2AHI9

&&2530”