Guilin Feiyu Technology Company 3AXISCAMERA Manual De Usuario

II  How to use Summon

1.  Function introduction of buttons and ports

1

Install battery

Power on:

Long press the function button until 
the green light up, then release it to 
turn on the gimbal.

Power off:

Long press the function button until 
the red light always on, then release 
it to turn off the gimbal.

          If the battery power is too low, 
the screen shall turn off automatically, 
please long press the function 
button for 3 seconds so as to make 
sure the unit completely powers off. 
Then you can recharge or replace 
the battery. 

Remove the hand 
shank and insert one 
22650 battery into it.

Single tap this button to switch 
below Photo mode and 
Video mode.

Long press this button to open 
WiFi function, and long press 
again to turn off WiFi function. 

The default is Video mode.

The function button can 
control power on or 
power off. 

2

Power on / off

Connect to a computer 
with USB data cable so 
as to read the video and 
picture files in a SD card.

SD reading port

Connect with USB data cable by this 
port to upgrade firmware or charge 
the battery. 

Please refer to “Firmware upgrade”
for the operation of firmware upgrade. 

Please refer to “Charging mode” for 
the charging mode.

USB port

How to use Summon

2

 Photo / Video 
 switchover button

USB port

Micro SD card *
    (Equipped by users)

* Class10 high-speed micro 
   SD card is recommended