Linksys Network Storage Link for USB 2.0 Disk Drives NSLU2-EU Manual De Usuario

9

Chapter 4: Setting Up the Storage Link

Now that everything is connected and powered on, you are ready to configure the Storage Link so that it is 
accessible to the users on your network. You will have to run the Storage Link ’s Setup Wizard on your PC to set 
up the Storage Link ’s basic settings. To run the Setup Wizard on your Windows 98, Me, NT 4.0, 2000, or XP PC, 
follow the instructions below.

1. Insert the Setup Wizard CD-ROM into your PC’s CD-ROM drive.

2. An autorun menu should appear after a few seconds. If the autorun menu does not appear, click the Start 

button, select Run, enter D:\SetupUtility.exe  (where D is the letter of your CD-ROM drive) into the field that 
appears and press Enter.

This Main Menu screen provides you with these options buttons:

Setup . Click the Setup button to continue with the setup procedure. 
Install Utility. If using a flash memory disk, install this utility (after the Setup Wizard) to map a flash memory 
disk to your PC. See Chapter 5: Install Utility for Flash Disks.
User Guide . Clicking on this opened this User Guide.
LINKSYS Web, connects you to the Linksys web site if you have an active Internet connection. 
Lastly, clicking the Exit button will exit the Setup Wizard.

After clicking the Setup button, follow these instructions.

3. From the following screen, the Setup Wizard will automatically search for any Storage Link currently on your 

network or attached to your PC. If it fails to detect the Storage Link or if a Storage Link has been installed 
since the Setup Wizard’s last search, click Search Again to locate the Storage Link. Select the Storage Link 
that you want to set up. Then, click the Yes button to change any of the Storage Link ’s settings or click the No 
button to accept the settings and exit the Setup Wizard.

 

Note: This procedure only has to be done once by the 
Storage Link ’s administrator.