Marshall V-R63P Prospecto

2.5”

5.8” LCD

Active Matrix

5.01” x 2.83”

each panel

0.318mm x

0.307mm

1200H x

234V

2 NTSC/PAL

per panel

Built into unit

19.125W x

5.14H x 2.5D

9 VDC

3.0 Amps

Display

Viewing Area

Dot Pitch

Inputs

Color Bars

Dimensions

Picture

Elements

Power

Consumption

1. The V-R63P has been designed to fit in a 3U space on your rack.  It is important to use 4 screws to hold the 

ears to the rack.  Be certain that the ears are aligned vertically, this is important to the tilt function. The 
auto signal detection will display a blue screen with the absence of a signal.  The V-R63P has a memory 
function that will remember the settings of each monitor including power and channel selection even if power 
has been disconnected from the unit.

2. Each LCD Panel comes with a protective plastic film that must be removed by carefully lifting the film from 

the corner and peeling it off.  Be certain not to apply any pressure on the LCD panels, they are fragile and can 
break.  Scratched, cracked or broken LCD screens are not covered by our warranty.

3.  The V-R63P uses 9VDC, 3.0amp regulated power.  Be certain that these specifications are met when using a 

power supply other than the one supplied to you by Marshall Electronics. The center pin on the coaxial power 
connector for the V-R63P is the POSITIVE terminal and the outside ring is NEGATIVE.  Any battery operation 
of the V-R63P must have this polarity configuration. 

4. The Video inputs on the rear of the panel are 75 Ohm self-terminated.  The loopthrough feature uses active 

components and is always active as long as power is supplied to the unit regardless of the monitor being ON or 
OFF.  Each screen has the capability to switch between NTSC and PAL signals.  This switch is located on the 
rear of the unit.  Once switched, both channels on that monitor will be set to either 
PAL or NTSC.  However, each screen is independently controlled. (cont. on back)

The V-R63P is a rack mountable unit that has three independently controlled 5.8" active matrix LCD panels with loop
through capability. These 16:9 high-resolution panels have a pixel count of 1200 × 234, and are rated at a very bright
350 candle luminance. Each of the three screens has a built-in color bar generator, controls for brightness, color, tint,
and contrast, and a selectable aspect ratio of 16:9 or 4:3. Each panel accepts two composite video inputs, and has a
selectable NTSC/PAL switch on the back. A built in 3 color tally system is also provided for each screen. Unit comes
complete with power supply, and fits into any standard EIA 19" rack, at only 3 rack spaces high.