Brodit 521379 Prospecto

1.

2.

4.

3.

Please read all of the instructions and look at the pictures before attaching the holder.  
 
Important note!  
Before using your OtterBox case with the Brodit holder we recommend the removal of the connector cover from
the OtterBox case, once this connector cover is removed from the case the device can be inserted and removed
from the holder with ease. Removing the OtterBox Connector Cover: 1. Lay the rubber skin of the OtterBox case
on a cutting surface so the connector cover is flat on the surface. 2. Using a ruler lay it flat across the case so
only the rubber connector cover part to be removed is visible. 3. Using a sharp knife blade cut along the ruler to
remove only the rubber connector cover. 4. Refit the OtterBox case to your device and then test in your Brodit
holder.  
 
Mounting the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching
plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into place with
the enclosed screws. 3. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel.
Screw a few turns on the screw, just so the thread starts to pull. Pull the holder toward you and hold it slightly
tensed, in the same time tighten the screw so the holder is pulled toward the tilt swivel. Tighten the screw until the
holder is firmly in place, but still can be adjusted. 4. The holder is in place.