Eaton 9135 UPS PPDM EPPDMG6000-3U-4 Manual De Usuario
Los códigos de productos
EPPDMG6000-3U-4
INSTALLATION
EATON Two-in-One PPDM (5000/6000 VA) User's Guide
S
164201820 Rev 1 www.eaton.com/powerquality
21
To hardwire the PPDM:
1.
Switch off utility power at the distribution point where the PPDM
will be connected. Be absolutely sure there is no power.
will be connected. Be absolutely sure there is no power.
2.
Verify that the PPDM output circuit breaker is in the OFF position
(see Figure 9 on page 23).
(see Figure 9 on page 23).
3.
Verify that the bypass switch on the PPDM is in the NORMAL
position (see Figure 8).
position (see Figure 8).
Bypass Switch
Voltage Switch
Figure 8. PPDM (with Front Cover Removed)
4.
Changing the PPDM voltage switch setting. When the PPDM voltage
switch is set to the 240V position (the default) with 240V input, the
output voltage is 240/120V. When set to the 208V position with
208V input, the output voltage is 208/120V. See Table 1 for a list of
PPDM input/output voltage settings. Figure 8 shows the voltage
switch.
switch is set to the 240V position (the default) with 240V input, the
output voltage is 240/120V. When set to the 208V position with
208V input, the output voltage is 208/120V. See Table 1 for a list of
PPDM input/output voltage settings. Figure 8 shows the voltage
switch.
NOTE In most applications, the voltage switch does NOT need changing.
To change the switch position, remove the bracket screw and turn
the switch. Flip the bracket around to fit the new position and
reinstall.
the switch. Flip the bracket around to fit the new position and
reinstall.