JVC LT-23D50 Manual De Usuario

- 14 -

Step 6: Switching the TV ON/OFF

To switch the TV on
Your TV will switch on

two steps:

1- Connect the power supply cord to the sys-

tem. Then the TV switches itself to stand-

by mode and the power lamp becomes

red located on the front of the TV.

2- To switch on the TV from stand-by mode

either:

Press the

button on the remote con-

trol or on the right side of the TV

or.
press a digit button on the remote control so

that a programme number is selected,
or,

Press

buttons on the right

side of the TV or on the remote control

, so

that last switched off programme is se-

lected.
By either ways the TV will switch on and the

power lamp will become green.
To switch the TV off

Press the

button on the remote con

trol or on the right side of the TV, so the TV

will switch to stand-by mode and the power

lamp will become red.

NOTE: To switch the TV off completely re-

move the mains plug from the socket.

Step 7: Initial settings

When the TV is first turned on, it goes into

the initial settings mode. Follow the instruc-

tions on the screen display to make the ini-

tial settings.

Note: If the

TV does not go into the initial settings mode

this is because your TV has already been turned on for

the first time. (Perform the initial settings with INSTALLA-

TION (see page

) in the DTV menu and AUTO STORE

(Analogue) (see page

) in the PROGRAM menu.)

Because this is the first time that

IDTV

has

been used, there are no channels stored in

the memory and below information will be

displayed on the screen.

1. Press the [OK] button to start the auto-

matic search.

35/LVW(PSW\6WDUWDXWRPDWLFVHDUFK

The IDTV will automatically tune to the UHF

transmission channels 21 to 68 looking for

digital terrestrial TV broadcasts and display-

ing the names of channels found. This pro-

cess will take about five minutes.

To cancel

searching, you can press MENU button at

any time during the process.

HINT: Depending on the reception conditions in your par-

ticular area, you may find that the list of channels found

includes one or more repeated names. This is because the

receiver may detect and store some channels, including

those it cannot receive clearly, from adjacent areas along-

side the strong channels from a transmitter nearby. This is

not a problem and the weaker channels can be deleted

from the receiver later, as described in - Edit PR List on
page

If no digital terrestrial television broadcasts

are found, the receiver will display a mes-

sage:

1RSURJUDPPHIRXQG

3OHDVHFKHFNDQWHQQDVLJQDO

When OK button is pressed, following

message will appear

on the right bottom of

the screen:

35/LVW(PSW\

2. When the automatic search has fin-

ished, the EDIT PR LIST menu appears.
If you want to, you can now edit the

programme numbers (PR) using the EDIT

PR LIST function. For details, see Edit PR

List on page

If you do not want to edit programme num-

bers (PR), go to the next step.
3. Press the MENU button.
The EDIT PR LIST menu disappears and

the following message appears

ENG-IDTV-JVC-1724W-17 INCH TFT LCD.230205.p65

24.02.2005, 08:19