Toshiba W-622 Manual De Usuario

1) While recording, press 

 to turn off

“VCR” indicator.

2) Choose another channel using the channel

selector on the TV.

Press 

 to stop recording

momentarily.  To resume recording, press

 again.

Note
The VCR automatically shifts to the stop mode if the
recording pause mode continues for 10 minutes.

Load a cassette with the safety tab attached.

Press 

TV/VCR so that the “VCR”

indicator appears in the VCR display.

Select a channel to record with
CHANNEL on the VCR, or CH/TRK
or 

number buttons on the remote

control.

If you see “L1” or “L2” in the VCR display, press 

 so that the

channel number appears.
• If you record cable channels via the cable box, make the output

channel number of the cable box or “L1” appear, depending on your
connection. (See pages 11 – 12.)

Press 

SP/SLP to select the

recording tape speed.

Suitable for general recording with

better picture and sound quality.
SLP: Suitable for tripling recording time, but with less picture and
sound quality than using the SP tape speed.

Press 

REC on the VCR, or

simultaneously press both 

REC on

the remote control.

Recording starts.

Press 

STOP to stop recording.

By setting the recording off time, the recording
stops and the VCR is turned off automatically.
While recording, press simultaneously both 

on the remote repeatedly to set the desired off
time.
Each time you press 

, each half-hour up to

about 4 hours appear cyclically.

Notes
• To cancel the recording in progress, press

POWER on the VCR.

This section explains the basic recording operation.

Preparation
• Select the video channel (3 or 4) or video input mode on the TV.

To record from other
connected equipment
In step 

, press 

I.SELECT to

switch the display as follows:
L1:  To record via the LINE IN
1 jacks on the rear panel.
L2: To record via the LINE IN
2 jacks on the front panel.

W-622 Eng (24-28)

2/28/02, 2:46 PM

24