TP-LINK TL-SG3424P Manual De Usuario

 

82

 

Clear the information in the log file: 

buffer 

The logging loghost command is used to configure the Log Host. To clear the 

configuration of the specified Log Host, please use no logging loghost 

command. Log Host is to receive the system log from other devices. You can 

remotely monitor the settings and operation status of other devices through the 

log host. 

{idx} {host-ip} {level} { disable | enable } 

{idx} 

 ——The index of the log host. The switch supports 4 log hosts. 

 —— The IP for the log host. 

 ——The severity level of the log information sent to each log host. There 

are 8 severity levels marked with values 0-7. The smaller value has the higher 

priority. Only the log with the same or smaller severity level value will be sent to 

the corresponding log host. By default, it is 6 indicating that the log information 

marked with 0~6 will be sent to the log host. 

disable | enable ——Disable or enable the log host. By default, it is disabled.   

Global Configuration Mode 

Enable the log host 2 and set the IP address 192.168.0.148, the level 5: 

2 192.168.0.148 5 enable 

The show logging lolcal-config command is used to display the configuration