Tripp Lite SmartRack SRCABLELADDER Manual De Usuario

SRCABLELADDER can provide enclosure-to-enclosure cable routing across an aisle or within a single row. You can combine multiple 

SRCABLELADDER and SRCABLETRAY accessories to meet the cable routing needs of almost any configuration of SmartRack Enclosures,

but planning and measurement are required to ensure a secure fit. Tripp Lite recommends that you read the entire manual in advance to gain a

clear understanding of the installation process and accessory positioning.

Use a tape measure to determine the distance that SRCABLELADDER will bridge. (Preassembling the ladder sections will allow you to observe

their attachment points in place for a more accurate measurement.)
The standard length of SRCABLELADDER is 10 feet. If the standard length and the distance between attachment points differ, adjusting the

position of the SRCABLETRAY accessories will allow you to change the distance between attachment points. If necessary, you can use a single

ladder section instead of two sections, reducing the overall ladder length to approximately 5 feet. In addition, the assembly brackets at the ends

of the ladder sections will allow minor adjustments if you install them without pins, and you can add a few inches to the length of the ladder 

by using the alternate pin holes for assembly. If the available adjustments will not accommodate the SRCABLELADDER accessory, you must

cut one of the ladder sections. See Section 3-2 Ladder Modification for instructions. If the SRCABLELADDER accessory will fit without

modification, proceed to Section 3-3 Ladder Assembly.

SRCABLETRAY

SRCABLETRAY

SRCABLETRAY

SRCABLELADDER installed
between enclosures across an aisle.

SRCABLELADDER installed
between enclosures within a row.