Tripp Lite B020-008 Manual De Usuario

5

Pull to slide the KVM module out; push to slide the
module in (see item 13 in this table).

After sliding the KVM module out, flip up the cover
to access the LCD monitor.

The LCD On/Off switch is located here, as well as 
buttons to control the position and picture settings 
of the LCD display. See p. 9 for details.

Press a switch to bring the KVM focus to the 
computer attached to its corresponding port. See 
p. 11 for details.

Two Port LEDs are built into the Port Switches. The one on the left is the On Line LED; the one on the 
right is the Selected Port LED:  

• An On Line LED lights ORANGE to indicate that the computer attached to its corresponding port 

is up and running.

• A Selected LED lights GREEN to indicate that the computer attached to its corresponding port is the 

one that has the KVM focus. The LED is steady under normal conditions, but flashes when its port 
is accessed under Auto Scan Mode (see p. 12).

Lights BLUE to indicate that the unit is receiving power.

The rack mounting tabs located at each corner of the unit secure the chassis to a system rack. Refer to 
Appendix D (p. 27), for rack mounting details.

The Num Lock, Caps Lock, Scroll Lock LEDs are located here.

Located to the right of the Lock LEDs. Press this recessed switch in with a thin object to perform a
system reset.

• Firmware Upgrade Port: The Firmware Upgrade Cable that transfers the firmware upgrade data 

from the administrator’s computer to the B020-008 or B020-016 plugs into this RJ-11 connector.

• Firmware Upgrade Switch: During normal operation this switch should be in the NORMAL

position. (See p. 21 for firmware upgrading details.)

In order to bring the console out, you must first release it by sliding these tabs to the inside. See p. 10 
for details on sliding the console in and out.

200506056 93-2463 Console KVM OM.qxd  6/29/2005  12:30 PM  Page 5