Britax Regent Manual De Usuario

Cover Removal

Cleaning the Cover

HAND WASH using cold water and mild soap.

LINE or LIE-FLAT DRY to prevent the cover from shrinking.

DO NOT

bleach, machine wash, machine dry or iron.

Cleaning the Shell

SPONGE CLEAN using warm water and mild soap.

TOWEL DRY

DO NOT

use solvents, abrasive cleaners or disassemble the

harness.

Cleaning the Harness

SPONGE CLEAN using warm water and mild soap.

TOWEL DRY

DO NOT

bleach, machine wash, machine dry or disassemble

the harness.

Cleaning the Harness Adjuster

Periodically check the adjuster area to be sure it is clean and free of

food, drink or other debris. If debris is present, it must be removed

to prevent interference with the adjuster mechanism.

BRUSH AWAY LOOSE DEBRIS using a soft-bristled brush.

SPONGE CLEAN using warm water and a mild soap.

TOWEL DRY

DO NOT

use solvents, abrasive cleaners or disassemble the

harness.

Care and Maintenance

WARNING!

Do not take apart the harness. Never remove

the buckle tongues from the harness. They cannot be

reattached after removal. If reassembled incorrectly, the child

seat may not perform as intended.

Loosen the harness by lifting the harness

adjuster lever while pulling the shoulder

straps forward as far as possible.

Unhook the shoulder straps from the harness

yoke on the rear of the child seat (Fig. A).

Pull the upper harness straps through the

shell and cover to the front of the child seat.

Remove the buckle and belly pad. See page 36.

Gently remove the upper portion of the cover. Be careful not to

damage the energy-absorbing foam.

Pull the lower harness straps, buckle tongues, HUGS™ chest

pads, and chest clip through the lower slots in cover.

Remove the entire cover from the child seat.

For additional demonstration please visit www.BritaxUSA.com.

Refitting the Cover

To refit the cover, reverse the above directions. Make sure that the

shoulder straps are not twisted, and are threaded properly through

the chest clips, cover, foam, and shell.