Cisco 1TB 7.2K SATA UCS-HDD1TI2F212= Manual De Usuario

A drive blanking panel (UCSC-BBLKD-L=) must be installed if you remove a disk drive from a UCS server. 
These panels are required to maintain system temperatures at safe operating levels, and to keep dust away 
from system components.

All Cisco UCS two CPU socket-capable servers can be upgraded from having one to having two CPUs 
configured. You will need to order and install a heat sink when adding any additional CPU to a server. 
Instructions for installing the new CPU and heat sink can be found at the following link:

You can order a replacement motherboard battery. Installation instructions are found at this link:

The Pick n Place tool set includes two tools:

■

Pick and pull cap tool - used to pull off the plastic protective cap covering an empty CPU socket and 

to remove or lift a CPU processor without touching it

■

Pick and place tool - used to install a CPU in its socket without damage. Must be used each time a 

CPU is installed in a UCS “M3” server.

Instructions for using this tool set are found at the following link:

2. If your server contains an LSI MegaRAID SAS 9266-8i RAID controller card with battery backup 

(UCS-RAID-9266), the card contains a battery backup unit (UCS-RAID-BBU), which can be replaced. If your 
server contains an LSI MegaRAID SAS 9266-8i RAID controller card without a battery backup unit 
(UCS-RAID-9266NB), the card does not contain a battery backup unit (UCS-RAID-BBU); however, you can 
retrofit the card with a battery backup if desired. Note that you cannot retrofit a UCS-RAID-9266NB or 
UCS-RAID-9266 RAID card with an LSI Cachevault Power Module (also known as a Supercap).

3. You can order a replacement only for the RAID cards listed. You cannot retrofit a UCS-RAID-9266NB or 

UCS-RAID-9266 RAID card with an LSI Cachevault Power Module (also known as a Supercap)

4. The server is shipped with the inner rail attached to the chassis.

5. This SD card is preloaded with an image specific to the C220 server.
6. This SD card is blank. The required image for the C220 server can be downloaded to the card.
7. This part is included/configured with the server chassis.
8. This part is included with the purchase of an optional or spare CPU processor kit.

NOTE:  When you purchase a spare CPU, the Pick n Place Toolkit is included.