ZyXEL Wireless Access Point G1000 91-005-124003B Manual De Usuario

G-1000 User’s Guide

102

Chapter 13 LAN Setup

Figure 55   Menu 3.5 Wireless LAN Setup

Note: In the SMT, the ESSID is referred to as SSID. Both of them refer to the same ID 
for the G-1000.

The following table describes the fields in this menu.

                                  Menu 3.5 - Wireless LAN Setup

     Name (SSID)= ZyXEL
     Hide Name (SSID)= No                 Edit MAC Address Filter= No
     Channel ID= CH06 2437MHz             Edit Roaming Configuration= No
     RTS Threshold= 2432                  Block Intra-BSS Traffic= No
     Frag. Threshold= 2432                Preamble= Long
     WEP Encryption= Disable              802.11 Mode= Mixed
       Default Key= N/A                   Max. Frame Burst= 0
       Key1= N/A                          Breathing LED= Yes
       Key2= N/A
       Key3= N/A                          
       Key4= N/A
       Authen. Method= N/A

Table 43   Menu 3.5 Wireless LAN Setup

Name (SSID)

The SSID (Service Set IDentity) identifies the AP to which the wireless stations associate. 

Wireless stations associating to the AP must have the same SSID. Enter a descriptive 

name of up to 32 printable 7-bit ASCII characters.
This field is only available when you select Access Point or AP + Bridge in the Operating 

Mode field.

Hide Name (SSID)

Press [SPACE BAR] and select Yes to hide the SSID in the outgoing data frame so an 

intruder cannot obtain the SSID through passive scanning.  

Channel ID 

Press [SPACE BAR] to select a channel. This allows you to set the operating frequency/

channel depending on your particular region. 

RTS Threshold

Setting this attribute to zero turns on the RTS/CTS handshake. Enter a value between 0 

and 2432.

Frag. Threshold 

This is the maximum data fragment size that can be sent. Enter a value between 256 and 

2432.

WEP Encryption

Select Disable to allow wireless stations to communicate with the access points without 

any data encryption. 
Select 64-bit WEP or 128-bit WEP to enable data encryption. 

Default Key

Enter the key number (1 to 4) in this field. Only one key can be enabled at any one time. 

This key must be the same on the G-1000 and the wireless stations to communicate.