ZyXEL Wireless Access Point G1000 91-005-124003B Manual De Usuario

G-1000 User’s Guide

Chapter 3 Introducing the Web Configurator

37

Figure 5   Change Password Screen

You should now see the MAIN MENU screen.

If you forget your password or cannot access the web configurator, you will need to reload the 
factory-default configuration file or use the RESET button on the side panel of the G-1000. 
Uploading this configuration file replaces the current configuration file with the factory-
default configuration file. This means that you will lose all configurations that you had 
previously. The password will be reset to 1234.

Make sure the SYS LED is on (not blinking) before you begin this procedure. 

Press

 the RESET button for ten seconds or until the SYS LED, LINK LED or BDG/

RPT LED turns red, and then release it. If the SYS LED begins to blink, the defaults have 
been restored and the G-1000 restarts. Otherwise, go to step 2.

2 Turn the G-1000 off.

While

 pressing the RESET button, turn the G-1000 on.

Continue 

to hold the RESET button. The SYS LED will begin to blink and

 

flicker very 

quickly after about 20 seconds. This indicates that the defaults have been restored and the 
G-1000 is now restarting.

Note: The management session automatically times out when 
the time period set in the Administrator Inactivity Timer field 
expires (default five minutes). Simply log back into the G-1000 if 
this happens to you.