Zebra HW46211 Manual De Usuario

Page 4-26

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A  1/24/06

Section 4

Maintenance

RRP No. 7: Adjust Rewind Drive Belt Tension

1. Refer to 

. Turn the printer Off (O) and disconnect the AC 

power cord and data cables.

2. Open the media cover.

3. Open the printhead and remove all media and ribbon. Close the printhead.

4. Refer to 

 and remove the electronics cover.

5. Refer to 

 and remove the power supply.

6. Refer to 

. Locate the idler pulley.

7. Refer to 

. On the media side of the printer, locate the lower access hole 

in the side plate. Remove the plug and extend the special tool (Zebra part 
number 11301) through the hole and loosen the idler pulley mounting screw.

8. Slide the idler pulley assembly toward the front of the printer to relieve the tension 

on the rewind drive belt.

9. Refer to 

. Hook a 2200-gram spring scale to the belt and slowly slide the 

idler gear assembly to the left to increase belt tension.

Unless indicated otherwise, turn the printer Off (O) and disconnect the printer 
from the power source before performing the following maintenance.

This installation must be performed by a qualified service technician.

Idler

Gear

2200

2000

1800

1600

1400

INCHES

1

2

3