Zebra HW46211 Manual De Usuario

13185L-002 Rev. A  1/24/06

110XiIIIPlus Maintenance Manual

Page 4-31

Maintenance

Section 4

9. Press SETUP/EXIT to enter the Configuration Mode.

10. Press PREVIOUS or NEXT/SAVE until HEAD RESISTOR is displayed.

11. Press the left or right oval; ENTER PASSWORD is displayed. Enter your password; 

the factory default password is 1234. Use the left oval to move the cursor to the digit 
you want to change, and then use the right oval to change the value. After your 
password is set, press NEXT/SAVE to enter the password.

12. Use the left and right ovals to change the Head Resistance, and then press NEXT/

SAVE to enter your resistance.

13. Press SETUP/EXIT, and then NEXT/SAVE to permanently save the Head 

Resistance.

14. Turn the printer Off (O), then perform the Pause Key Self Test by pressing and 

holding PAUSE while turning On (l) the printer, and check print quality.

If the HEAD TEST COUNT and
HEAD RESISTOR settings appear
on the configuration label, go to
Step 9. If neither setting appears,
go to

.