Zebra HW46211 Manual De Usuario

13185L-002 Rev. A  1/24/06

110XiIIIPlus Maintenance Manual

Page 4-95

Maintenance

Section 4

Adjust Peel-Off Mode 

Lower Roller 

If the media walks from side to side, it may be necessary to adjust the position of the lower 

roller.

Refer to 

1. Loosen the two screws (8) securing the platen support bracket (7) to the side plate.

2. Moving the bracket toward the rear of the printer forces the media to wind closer to 

the main frame. Moving the bracket toward the front moves the media away from 
the main frame. Adjust as required and tighten screws.

3. Perform this adjustment until required results are achieved.

Tension

For liner and label combinations that are particularly difficult, it may be necessary to 

increase rewind tension in Peel-Off Mode. Follow the same tension adjustment procedures 

on the previous page used to 

Spring Scale

Adjusting Nut

Polyester Strip