Zebra HW46211 Manual De Usuario

Page 1-10

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A 1/24/06

Section 1

System Description

Cabling Requirements

Data cables must be fully shielded and fitted with metal or metallized connector shells. 

Shielded cables and connectors are required to prevent radiation and reception of electrical 

noise. 

To minimize electrical noise pickup in the cable:

•

Keep data cables as short as possible.

•

Do not bundle the data cables tightly with the power cords.

•

Do not tie the data cables to power wire conduits.

Cable Connections

Parallel Data Port

Refer to 

When communicating via the parallel port, refer to 

 to configure the 

communication parameters for the printer.

Note • Zebra printers comply with FCC “Rules and Regulations,” Part 15, 
Subpart J, for Class A Equipment, using fully shielded 6

′ (2 m) data cables. Use 

of longer cables or unshielded cables may increase radiated emissions above 
the Class A limits.

RS-422 and RS-485 applications should use twisted shielded pairs as 
recommended in the TIA/EIA-485 specifications.

10 ft (4.5 m) maximum

25-pin

male

36-pin

male

PC

25-pin

female