Zebra HW46211 Manual De Usuario

Page 2-22

110XiIIIPlus Maintenance Manual

13185L-002 Rev. A 1/24/06

Section 2

Operations Overview

7. The printer automatically adjusts the base settings as determined by the media and 

ribbon sensors according to the specific media and ribbon combination you are 
using. When this part of the calibration process is completed, the front panel LCD 
shows:

8. Open the printhead and pull the media forward until a label is positioned under the 

media sensor.

9. Move the ribbon back to its proper position. To ensure that the ribbon is smooth, 

rotate the take-up spindle a couple of turns.

10. Close the printhead.

11. Press the right oval key to continue. The printer performs the second part of the 

calibration process and the front panel LCD shows:

The media sensor determines label length and a new value based on the presence of media 

and liner. The ribbon sensor determines a new value based on the presence of ribbon. 

Once media stops feeding, the calibration process is complete.

12. Press SETUP/EXIT to leave Program Mode. When prompted to SAVE 

CHANGES PERMANENT, press NEXT/SAVE to save permanently. The front 
panel LCD shows:

RELOAD ALL

CONTINUE

MEDIA AND RIBBON

CALIBRATE

SAVE CHANGES

PERMANENT