Zebra HW46211 Manual De Usuario
13185L-002 Rev. A 1/24/06
110XiIIIPlus Maintenance Manual
Page 4-19
Maintenance
Section 4
RRP No. 4: Remove and Install the Main Logic Board
Remove the Main Logic Board
1. Refer to
. Turn the printer Off (O) and disconnect the AC
power cord. Disconnect the data cables.
2. Refer to
and remove the electronics cover.
3. Refer to
. Remove the memory or font card from the card slot at the rear
of the printer by removing the shield and pressing the card-eject button.
Figure 4-9. Memory or Font Optional Board
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
from the power source before performing the following maintenance.
Caution:
This installation must be performed by a qualified service technician.
Note • Retain all attaching hardware to use during reassembly.