Zebra HW46211 Manual De Usuario
13185L-002 Rev. A 1/24/06
110XiIIIPlus Maintenance Manual
Page 4-57
Maintenance
Section 4
Remove and Install the Cutter PCB
1. Refer to
. Turn the printer Off (O), remove the AC power
cord and data cables.
2. Refer to
and remove the electronics cover.
3. Refer to
4. Refer to
and disconnect all cables from the cutter PCB.
5. Refer to
. Remove the screws securing the cutter PCB.
6. Remove and discard the cutter PCB.
Figure 4-33. Remove and Install the Cutter PCB
Caution:
The printer electronics are susceptible to static discharge. Before proceeding, it
is highly recommended that the technician wear an antistatic wrist strap
connected to the printer chassis.
is highly recommended that the technician wear an antistatic wrist strap
connected to the printer chassis.
Caution:
Unless indicated otherwise, turn the printer Off (O) and disconnect the printer
from the power source before performing the following maintenance.
from the power source before performing the following maintenance.
Caution:
This installation must be performed by a qualified service technician.
Electric
al
Danger
Mounting
Screw
Cutter PCB
Ribbon Cable
J4