Philips 1190XD/44 Manual De Usuario

C

 

  Place the razor into the holder behind the 

two clips (1) and press the razor down to 

lock into place (2). 

The display on the razor will indicate razor is 

charging. 

C

 

  Press the ON/OFF button on the Jet 

Clean System to start the cleaning cycle.

The razor display stops showing the charging 

indication.  

 

C

 

  The cleaning light starts to blink and the 

razor is automatically lowered into the 

cleaning solution. 

The razor stops charging while it is being cleaned.

 

◗

  During the first phase of the cleaning cycle, 

the razor will automatically turn on and off 

several times while the razor holder lowers 

and raises the razor’s position in the cleaning 

solution, removing all debris.  The cleaning 

light will blink continuously throughout the 

cleaning program. 

C

  ◗  During the second phase of the cleaning cycle,  

the razor holder moves the razor to the  

drying position and the drying light will blink. 

This phase will take approximately 2 hours.  

The razor will stay in one position until the 

end of the drying program. 

 

◗ 

Do not press the ON/OFF button while the 

cleaning cycle is running.  If this does occur, the 

cleaning cycle will stop and the razor holder 

will automatically move to the starting 

30

31

1

2

 

position. The cleaning cycle can be re-started 

by pressing the ON/OFF button once. 

 

◗

  If the power plug is disconnected before the 

  

cleaning cycle is complete, the razor holder will  

remain in its current position.  Reconnect the   

plug into the outlet or Jet Clean System and the 

razor holder will automatically move to the   

highest position.  The cleaning cycle can be  

re-started by pressing the ON/OFF button once.

  

C   

NOTE: If the cleaning solution level drops below 

the minimum level during the cleaning cycle, the 

‘cleaning chamber empty’ symbol will blink and 

razor holder returns the razor to the starting 

position, stopping the cleaning cycle. Unplug Jet 

Clean System from the outlet, remove razor and 

refill canister (see “Preparing Jet Clean System 

for Use”).

 

 

   When the entire cleaning cycle is complete 

and the razor is hygienically clean, the 

razor will be raised to the starting position 

and the display on the razor will turn on 

indicating that the razor is (re)charging. 

  

  Pull the razor forward and lift razor from 

Jet Clean System.

 

◗

  If the razor needs to be recharged, you can 

  

simply leave it in the Jet Clean System after   

cleaning and the razor will automatically  

recharge. The display on the razor will indicate 

the razor is recharging.