Cisco Spare 625W Power Supply for Cisco MCS 7835-I1 PWR-7835-I1= Hoja De Datos
Los códigos de productos
PWR-7835-I1=
© 2006 Cisco Systems, Inc. All rights reserved.
Important notices, privacy statements, and trademarks of Cisco Systems, Inc. can be found on cisco.com.
Page 3 of 8
illuminated remain illuminated when the server shuts down as long as the AC power source is good and the power supply can provide +5 VDC to
the server.
Light Path Diagnostics provide indication of failures for the following conditions:
•
One or both power supplies are consuming power higher than maximum rating
•
Power Supply 1 failure
•
Power Supply 2 failure
•
Error on Voltage Regulator Module
•
One or both processors failed
•
Hardware configuration error occurred
•
Memory error
•
Non-maskable interrupt occurred
•
Error occurred on the system board
•
Service processor failure
•
Error occurred on adapter in PCI-X slots A, B, or C
•
Hard disk error occurred
•
Fan failure or slow operation
•
System temperature exceeded maximum rating
•
Soft error occurred
•
RAID controller error occurred
Enhanced Predictive Failure Analysis
The Cisco MCS 7835-I1 supports Enhanced Predictive Failure Analysis (PFA) on hot swap fans, power supplies, processors, and memory and
voltage regulator modules. Through diagnostics the Cisco MCS 7835-I1 anticipates failures in these devices and generates an alert, which allows IT
to quickly replace the components before a failure actually occurs. An example of PFA is its ability to monitor variations in electrical input/output to
the power supplies and cooling fans.
36/72GB DAT Tape Support
The Cisco MCS 7835-I1 can support an optional 36/72GB universal serial bus (USB) external Digital Audio Tape (DAT) DAT drive (part number
DAT-USB-EXT-72=) or an optional USB rack-mount DAT drive (part number DAT-UDB-RM-72=). This tape drive connects through one of the
4 USB 2.0 ports provided by the Cisco MCS 7835-I1 server.
PRODUCT SPECIFICATIONS
Table 1.
Product Specifications
Processor at Product Introduction
Processor (CPU)
Xeon DP
Processor internal clock speed
3400 MHz (or higher)
Level 2 cache
2048 KB
Maximum processors
2
Processors installed
1
Basic input/output system (BIOS) type
Flash