HID Identity 300x iCLASS SE 3003VGGNN Manual De Usuario
Los códigos de productos
3003VGGNN
iCLASS SE How To Order Guide – D00545, C.8
February 2014
© 2007-2014 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
Page 45 of 48
Programming Cards
Use these cards for customer reader configuration. Readers may be reconfigured to a target configuration by applying the correct target configuration. Use the following link and select
to the reader security using programming cards. Contact HID Technical Support (
) to ensure selecting the proper settings.
Reader Configuration
Description
Part Number
Base Part No.
Elite (E) or Standard Security (0 or 2)
1
Configuration Settings
2
Reader Configuration Cards
SEC9X-CRD-
E = Elite Key
0 = Standard key 1 or standard key 2
0 = Standard key 1 or standard key 2
-XXXX = Specific configuration
Reconfigure reader to factory standard
settings
4
0000 = Factory configuration (Rx models)
-0001 = Factory configuration (RPx models)
-0002 = Factory configuration (RKx models)
-0003 = Factory configuration (RPKx models)
-0002 = Factory configuration (RKx models)
-0003 = Factory configuration (RPKx models)
Security downgrade card
Add standard iCLASS access control
Add standard iCLASS access control
application to your iCLASS SE or multiCLASS
SE reader
SEC9X-CRD-
Contact your HID Support Representative (
Security upgrade card (key rolling)
Setup iCLASS SE or multiCLASS SE readers
Setup iCLASS SE or multiCLASS SE readers
for SIO (and optionally Prox) interpreters only.
1
Keys
Specify Elite “E” or Standard-1/Standard-2 ”0” based upon keys ALREADY LOADED in the reader that needs to be configured.
2
Configuration Settings
All standard readers ship with the following features - 13.56MHz interpreter “T” enabled, Wiegand “N” enabled, and Standard-1 “0” security keys enabled. ANY other option selected requires a specific configuration EXTENSION. To order non-standard
configuration options, use the following link and select the iCLASS SE Configuration Worksheet under Related Documents.
. Your HID Global Support or Sales representative can help you determine
your final configuration.
Standard configuration includes: LED normally Red + Reader beeps / flashes LED green on card read + Intelligent Power Management = Off + Keypad Output is 4-bit (if keypad reader) + 125 kHz HID Prox, AWID, Indala (ASP10022), EM4102 (if
multiCLASS SE).
Note: Reader configuration cards change settings in an additive fashion. Configuration card settings only overwrite old settings for the options selected. Reader settings that have not been selected for the configuration retain their original values.
To reset reader settings to factory defaults, use a factory default configuration card first, then apply the new configuration with the provided reader configuration card.