Philips Micro music system DCB2020 DCB2020/79 Manual De Usuario
Los códigos de productos
DCB2020/79
10 EN
4 Get started
Caution
•
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
Always follow the instructions in this chapter in
sequence.
Turn on
Press .
»
This product switches to the last
selected source.
Switch modes
Automatically switch the modes:
• After this product keeps inactive for 15
minutes, it automatically switches to the
normal standby mode.
• After this product keeps in the normal
standby mode for 15 minutes, it
automatically switches to the eco power
standby mode.
Manually switch the modes:
• Press and hold to switch this product:
• from the working mode or normal
standby mode to the eco power
standby mode.
• from the eco power standby mode to
the normal standby mode.
• Press to switch this product
• between the working mode and a
standby mode.
Note
•
When an iPod/iPhone/iPad is connected, this product
does not switch to the eco-power standby mode.
Set clock
1
In standby mode, press and hold
PROG/CLOCK SET to activate clock
setting.
»
[CLOCK SET] (set clock) scrolls on
the display, and then [CLOCK 24]
(24-hour time format) is displayed with
"24" blinking.
2
Press / or VOL +/- to select
[CLOCK 24] or [CLOCK 12] (12-
hour time format), and then press
PROG/CLOCK SET.
»
The hour digits begin to blink.
3
Press / or VOL +/- to set the hour.
4
Press PROG/CLOCK SET again.
»
The minute digits begin to blink.
5
Press / or VOL +/- to set the minute.
6
Press PROG/CLOCK SET to confirm the
clock setting.
»
The set clock is displayed.
• To exit clock setting without storing,
press .
Note
•
If no button is pressed in 90 seconds, the system exits
clock setting mode automatically.
Tip
•
To adjust the digits of hour or minute, you can also turn
the VOLUME knob or press PRESET/ALBUM +/- on
the main unit.
Demonstrate features
1
In normal standby mode, press .
• [WELCOME TO PHILIPS] (welcome
to Philips) scrolls on the display, and
then feature names one by one.
2
To exit the feature demonstration, press
again.