Philips Table lamp 31668/87/46 316688746 Manual De Usuario
Los códigos de productos
316688746
2
PART B
-
S
N
O
I
T
C
U
R
T
S
N
I
Y
T
E
F
A
S
E N G L I S H
•
n
it
h
g
il
f
o
e
s
u
t
c
e
r
r
o
c
e
h
t
s
e
s
i
v
d
a
r
e
r
u
t
c
a
f
u
n
a
m
e
h
T
ttings! Therefore always follow these instructions to
ensure correct and safe installation and functioning of th tting and keep it for future reference.
• Always isolate the power before commencing installation, maintenance or repair.
•
Consult a quali
ician or contact your retail outlet. Ensure that you always install
the tting
to the relevant regulations. Certain regulations indicate that lightin ttings should be installed
by a
ician (EG Part P for the UK ,
AS / NZS3000 IN for AUSTRALIA / NEW ZEALAND
)
• Always tighten the terminal sc
mly, especially the attachment for low voltage wiring (12V) (if
applicable).
• Observe the correct colour of the wiring before installation: blue (N), brown (L) and if protection class I,
yellow/green (earth).
• Maintain interior lighting with a dry cloth duster, do not use abrasives or solvents. Avoid liquid on all
electrical parts.
• Please mount wall lights out of children's reach.
• If the luminaire is mounted on a metallic surface, this surface must be bonded to the protective earth
conductor or to the equipotential bonding conductor of the installation.
• Always
•
with icons, as per International norms & safety standards. However not all of them may be
applicable for the model you purchased - please refer to the icons on the additional Manual A,
for the ones which are particularly applicable for this model.
consider all the technical speci
tions of th
tting. Verify the stated icons on the identi
tion
label on th
tting and the icons that are shown in part A of your safety instructions.
li
w
:
Below you
N
O
I
T
N
E
T
T
A
all the explanations with numeric reference to the icons respectively
in front of these safety instructions:
01- This
should only be installed indoors.
02- The
is not suitable for installation in bathrooms at least not in the
zone.
03- The
is suitable for
to normal
surfaces.
Recessed luminaires should under no circumstances be covered with insulation material or other
similar materials.
04- This product is not suitable for direct mounting on
surfaces.
05- The
may be covered with insulating material.
06- The
is only suitable for
to the ceiling.
07- The
is only suitable for
to the wall.
08- The
is suitable for
to the wall and to the ceiling.
09- Always observe the minimum distance between the lamp and the surface being lit as indicated on the
icon.
10- IPX1: The
is protected against dripping water.
11- IPX3: the
may be exposed to raindrops (falling drops under a maximum angle of 60° to the
vertical axis).
COOL
BEAM
33
34
35
36
41
37
38
39
40
MIN 00 SEC
MAX 00
NI
M
42
43
44
45
46
47
48
49
50
51
52
MAX 4°
000°
00m
00m
00m
MAX
6m
...
...
Ø
licensed