Hitachi RAK-35QXA RAK35QXA Manual De Usuario
Los códigos de productos
RAK35QXA
10-14
2. Wall Penetration and Installation of Protection Pipe
•
Drill an Ø65mm hole on wall which is slightly tilted
towards the outdoor side. Drill the wall at a small
angle
towards the outdoor side. Drill the wall at a small
angle
•
Cut the protection pipe according to the wall
thickness
thickness
•
Empty gap in the sleeve of protection pipe should
be completely sealed with putty to avoid dripping
of rain water into the room.
be completely sealed with putty to avoid dripping
of rain water into the room.
WARNING
•
Be sure that the wire is not in contact with any
metal in the wall. Please use the protection pipe as
wire passing through the hollow part of the wall so
as to prevent the possibility of damaged by mouse.
Unless it seals completely, any air with high
humidity flows from outdoor and dew may drop.
metal in the wall. Please use the protection pipe as
wire passing through the hollow part of the wall so
as to prevent the possibility of damaged by mouse.
Unless it seals completely, any air with high
humidity flows from outdoor and dew may drop.
Installation of the indoor unit
How to remove the front cover
1. Remove the front panel (refer to instructions on the
1. Remove the front panel (refer to instructions on the
reverse of this sheet)
2. Remove the front cover
•
Remove the two bottom screws and two top
screws. Pull the front cover approximately 30mm
towards you.
screws. Pull the front cover approximately 30mm
towards you.
※ When attaching the front cover, follow the above
procedure in reverse order. Make sure the hooks at the
front cover top surface are securely inserted into the
cabinet.
procedure in reverse order. Make sure the hooks at the
front cover top surface are securely inserted into the
cabinet.
•
If there is a baseboard
If the
baseboard is
5~15mm in
thickness or
70~130mm in
height, cut
the pipe
bushing to
conform to
the
baseboard.
baseboard is
5~15mm in
thickness or
70~130mm in
height, cut
the pipe
bushing to
conform to
the
baseboard.
For sideways piping
For right or left
sideways piping, cut
the cabinet’s bushing
with a plastic cutter or
similar tool and use a
file for an attractive
finish.
sideways piping, cut
the cabinet’s bushing
with a plastic cutter or
similar tool and use a
file for an attractive
finish.
Connecting the pipe to indoor unit
•
•
Draw in the pipes through the hole of the wall or the
floor to indoor.
floor to indoor.
•
Arrange the pipe shown below. In the case that large
pipe and small pipe arrange to make in front and
behind.
pipe and small pipe arrange to make in front and
behind.
•
The indoor piping should be insulated with the enclosed
insulation pipe.
insulation pipe.
•
The pipe should first be cut longer than the length
shown below.
shown below.
•
The excess section of the pipe should be cut off during
pipe connection.
pipe connection.
•
In the case of
make a hole on
the floor
make a hole on
the floor
Indoor
Seal with
putty
2~5mm
Seal with
putty
Sleeve of
protection
pipe
Protection
pipe
Screw (2 pieces)
Cabinet
Front Cover
Screw (3 pieces)
Baseboard
130
70
5
15
Floor
23
0
30