Hitachi RAK-18PSA RAK18PSA Manual De Usuario
Los códigos de productos
RAK18PSA
10-44
10.3 FINAL STAGE OF INSTALLATION
10.3.1. INSULATION AND MAINTENANCE OF
PIPE CONNECTIONS
•
The connected terminals should be completely
sealed with heat insulator and then tied up with
rubber strap.
sealed with heat insulator and then tied up with
rubber strap.
•
Please tie the pipe and power line together with
vinyl tape as shown in the figure showing the
installation of Indoor and Outdoor units. Then fix
their position with holders.
vinyl tape as shown in the figure showing the
installation of Indoor and Outdoor units. Then fix
their position with holders.
•
To enhance the heat insulation and to prevent
water condensation, please cover the outdoor part
of the drain hose and pipe with insulation pipe.
water condensation, please cover the outdoor part
of the drain hose and pipe with insulation pipe.
•
Completely seal any gap with putty
10.3.2. INSTALLATION OF REMOTE
CONTROLLER
•
The remote controller can be placed in its holder
which is fixed on wall or beam
which is fixed on wall or beam
•
To operate the remote controller at its holder,
please ensure that the unit can receive signal
transmitted from the controller at the place where
the holder is to be fixed. The unit will beep when
signal is received from the remote controller. The
signal transmission is weaken by the fluorescent
light. Therefore, during the installation of the
remote control holder, please switch on the light,
even during day time, to determine the mounting
location of the holder.
please ensure that the unit can receive signal
transmitted from the controller at the place where
the holder is to be fixed. The unit will beep when
signal is received from the remote controller. The
signal transmission is weaken by the fluorescent
light. Therefore, during the installation of the
remote control holder, please switch on the light,
even during day time, to determine the mounting
location of the holder.
The controller must
be hooked onto the
hook at the lower
part of the holder.
Push in the remote
controller in the
direction as shown
in figure below.
be hooked onto the
hook at the lower
part of the holder.
Push in the remote
controller in the
direction as shown
in figure below.
Indoor 5 Indoor 6
L5
L6
Insulation material for pipe connection
Sleeve of
protection pipe
Indoor 5 Indoor 6
L6
L5
Putty
Putty
Screw (2 pieces)
Holder for
Remote
controller
Remote
control