UTAX P-4530DN 4434500000 Manual De Usuario

Maintenance 

7-2

The printer displays messages at two stages of toner usage:

• When the printer becomes low on toner, the printer displays the message Toner is running out. as the first 

caution. Note the replacement is not always necessary at this stage. Prepare the new toner kit.

• If you ignore the above message and continue printing, the printer displays the message Replace the toner. - just 

before the toner is used up. The printer will stop printing. The toner container must be replaced immediately.  Refer to 
Replacing the Toner Container on page 7-3.

The life of the toner containers depends on the amount of toner required to accomplish your printing jobs. According to ISO/
IEC 19752 and EcoPrint switched off the toner container can print as follows (A4/Letter paper is assumed):12,500 images 
(P-4030D and P-4030DN), 15,500 images (P-4530DN) or 25,000 images (P-5030DN and P-6030DN).

The toner container packed with the new printer is a starter toner container. The starter toner container lasts an average of 
6,000 images (P-4030D and P-4030DN), 8,000 images (P-4530DN) , or 10,000 images (P-5030DN and P-6030DN).

For best results, we recommend that you only use genuine Parts and Supplies. Should any damage be caused by the 
application of a toner other than the original toner, then this damage is excluded from the guarantee.

A new toner kit contains the following items:

• Toner Container
• Plastic waste bags for old toner container and old waste toner box
• Waste Toner Box
• Installation Guide

Information Collection on Memory Chips - The memory chip attached to the toner container is designed to 

improve convenience for the end user; to support the recycling operation of empty toner containers; and to gather 
information to support new product planning and development. The information gathered is anonymous - it cannot 
be associated to any specific individual and the data is intended to be used anonymously.

Do not remove the toner container from the carton until you are ready to install it in the printer.