MIPRO ACT-52 ACT 52(6A) Manual De Usuario
Los códigos de productos
ACT 52(6A)
RECEIVER VFD INTERFACE
Displays all Parameters
Working Frequency
4
Transmitter Battery Meter
8
10
Audio Signal Meter
2
Interference Indicator (lit denotes presence of interference)
6
Preset Channels (can be programmed)
1
RF Signal Meter
5
Squelch Meter (levels can be programmed)
9
Group (can be programmed)
Diversity A/B Antenna
3
Working Channel
7
AF
A
B
1
2
3
4
5
6
7
8
SQ
MHz
GRP
BAT
ACT
MENU
Display Panel and Buttons
10
11
Diversity Receivers
Diversity Receivers
5
4
3
2
8
7
9
6
AF
A
1
2
3
4
5
7
8
SQ
MHz
GRP
BAT
6
1
10
Receiver Parameters
3 parameters can be selected and programmed by the button.
See instructions below:
MENU button: To set receiver parameter values
MENU
GROUP setting
GRP
AF
A
1
2
3
4
5
6
7
8
SQ
MHz
GRP
BAT
Blinking GRP cursor
ACT
MENU
Press once to increase
by one group
by one group
Press once to decrease
by one group
by one group
Press Once
Instructions:
1.
Press and release the button once. The ----GRP---- cursor starts blinking to
denote it is ready to accept parameter changes.
denote it is ready to accept parameter changes.
2.
During blinking, press or button to one of the 6 groups.
3.
Press and release the button once to confirm the change. The ----GRP----
cursor stops blinking and the new group is now stored into memory.
cursor stops blinking and the new group is now stored into memory.
To exit GRP mode:
1.
GRP mode deactivates automatically if or button is not pressed within 5
seconds. The VFD panel dims automatically, too.
seconds. The VFD panel dims automatically, too.
MENU
MENU