Rigol DS2072A 2-channel oscilloscope, Digital Storage oscilloscope, DS2072A Manual De Usuario
Los códigos de productos
DS2072A
RIGOL
DS2000A User’s Guide
12-2
To Output Basic Waveform
To Output Sine
Press Src1 Setup to open the waveform setting menu. Press Wave and select
“Sine”. At this point, you can set the sine parameters.
1. Source
Press Source to turn on or off the signal output.
2. Set the frequency
Press Frequency to set the frequency of the signal. The range is from 100 mHz
to 25 MHz. Note that for different waveforms, the frequency ranges are different.
The frequency range of square and pulse is from 100 mHz to 15 MHz; the
frequency range of ramp is from 100 mHz to 100 kHz.
Method 1:
Rotate
to 25 MHz. Note that for different waveforms, the frequency ranges are different.
The frequency range of square and pulse is from 100 mHz to 15 MHz; the
frequency range of ramp is from 100 mHz to 100 kHz.
Method 1:
Rotate
or the navigation knob to set the desired frequency value.
Method 2:
Press down
Press down
and the numeric keyboard is displayed. Use the knob to input
the desired frequency value and unit.
3. Set the amplitude
Press Amplitude to set the amplitude of the signal. When the impedance is set
to HighZ, the range is from 20 mVpp to 5 Vpp; when the impedance is set to 50
Ω, the range is from 10 mVpp to 2.5 Vpp. For the setting method, please refer to
the introduction in
to HighZ, the range is from 20 mVpp to 5 Vpp; when the impedance is set to 50
Ω, the range is from 10 mVpp to 2.5 Vpp. For the setting method, please refer to
the introduction in
4. Set the DC offset voltage
Press Offset to set the DC offset of the signal. When the impedance is HighZ,
the range is from (-2.5 V+the current amplitude/2) to (2.5 V-the current
amplitude/2); when the impedance is set to 50 Ω, the range is from (-1.25 V+the
current amplitude/2) to (1.25 V-the current amplitude/2).
Method 1:
Rotate
the range is from (-2.5 V+the current amplitude/2) to (2.5 V-the current
amplitude/2); when the impedance is set to 50 Ω, the range is from (-1.25 V+the
current amplitude/2) to (1.25 V-the current amplitude/2).
Method 1:
Rotate
or the navigation knob to set the desired DC offset voltage.
Method 2:
Press down
Press down
and the numeric keyboard is displayed. Use the knob to input