Lecroy WAVEACE 1012 2-channel oscilloscope, Digital Storage oscilloscope, WaveAce 1012 Manual De Usuario
Los códigos de productos
WaveAce 1012
Operator's Manual
86
WA1K2K-OM-E RevB
Utility Menu - Page 3/4
1. Press the Update Firmware option button to update the
oscilloscope using the USB memory device. For more information,
see the Updating the System Software (on page 90) section.
see the Updating the System Software (on page 90) section.
2. Pressing the Pass/Fail option button shows the Pass/Fail menu
where you can monitor changes of signals and output pass or fail
signals by judging whether the input signal is within the
predefined mask. For more information, see Using Pass/Fail (on
page 93).
signals by judging whether the input signal is within the
predefined mask. For more information, see Using Pass/Fail (on
page 93).
3. Pressing the Record option button shows the Record menu where
you can record the input waveform from CH1 and CH2 (also, CH3
and CH4 on four channel versions), with a maximum record length
of 2500 frames.
and CH4 on four channel versions), with a maximum record length
of 2500 frames.
You can record Pass/Fail test output (especially useful when
capturing abnormal signals over a long period of time) without
having to watch the signal.
capturing abnormal signals over a long period of time) without
having to watch the signal.
Just set the source, the time interval between record frames, and
the maximum number of record frames. For more information,
see Using Record (on page 96).
the maximum number of record frames. For more information,
see Using Record (on page 96).
4. With your oscilloscope connected to your network, pressing the IP
Setting option button shows Internet Protocol values for your
specific IP Address, Subnet Mask, Gate Way, Port, Mac Address,
and DHCP.
specific IP Address, Subnet Mask, Gate Way, Port, Mac Address,
and DHCP.