Greisinger SET 38 MPA MPA wood moisture set Compatible with GMH and GMH 3850 Interface cable 602122 Prospecto
Los códigos de productos
602122
Z23.0.21.6C-01
Wood / Material moisture measuring case
SET 38 MPA
for the glued timber construction acc. to DIN 1052-1
(MPA certified)
Scope of delivery
• Measuring cable GMK38
• Reciprocating piston electrode GHE91 with steel pins GST91 (2 packages)
• Temperature probe GTF38
• Transportation case GKK3500
The instruments GMH3830 / GMH3850 with its curve h.460 (Fir) was certified by the MPA Stuttgart
(Otto Graf institute) for applications in the glued timber construction according to DIN 1052-1
• Reciprocating piston electrode GHE91 with steel pins GST91 (2 packages)
• Temperature probe GTF38
• Transportation case GKK3500
The instruments GMH3830 / GMH3850 with its curve h.460 (Fir) was certified by the MPA Stuttgart
(Otto Graf institute) for applications in the glued timber construction according to DIN 1052-1
Hints for reciprocating piston electrode GHE91
ATTENTION when using the reciprocating piston electrode! Risk of injury!
Intended purpose:
The reciprocating piston electrode is only allowed to be used for moisture
measuring of wood and materials that are soft enough, not to damage the steel
needles, when punching in the electrode in. The connection is done via 4mm
banana plugs. Only suitable steel needles are allowed to be used.
measuring of wood and materials that are soft enough, not to damage the steel
needles, when punching in the electrode in. The connection is done via 4mm
banana plugs. Only suitable steel needles are allowed to be used.
Insert needles into the needle-holder (2) and tighten with a flat wrench (wrench
size 12 mm). Its essential to verify that the needles are tightened well enough
before punching the electrode into materials.
size 12 mm). Its essential to verify that the needles are tightened well enough
before punching the electrode into materials.
Bring the needles into desired position and knock the sliding weight (1) by hand
towards the needles. The other hand can hold the upper part of the electrode.
Be careful to hold the weight in a way not to squeeze Your fingers when
knocking!
towards the needles. The other hand can hold the upper part of the electrode.
Be careful to hold the weight in a way not to squeeze Your fingers when
knocking!
Always punch the electrode in upright, when not doing so, the needles may
bend/break.
bend/break.
Bent needles should be replaced for safety reasons.
Pulling out tight needles: Knock the weight in the other direction (away from the
needles)
Try not affecting the needles by lever action, because they may bend/break.
needles)
Try not affecting the needles by lever action, because they may bend/break.
Always keep the impact electrode and the connections/plugs clean, because
measurements might be falsified when not doing so.
measurements might be falsified when not doing so.
The temperature probe GTF38 is suitable to be stuck into wholes punched by the needles!
GREISINGER
electronic GmbH
D - 93128 Regenstauf, Hans-Sachs-Straße 26
Fax: 09402 / 9383-33, Tel.: 09402 / 9383-0, Email: info@greisinger.de