Voltcraft K201®Temperature meter, thermometer 300 Manual De Usuario

Los códigos de productos

300

Advice!
A short 'beep' from the built-in bleeper sounds in confirmation
every time a key is pressed.

C3 Bush occupancy

a) Measuring imput
The measuring bush is a so-called unipolar (+ and -) knife-edge
contact bush. You must connect this bush to the K type tempera-
ture sensor if you want to carry out temperature measurements
correspondingly to the sensor specification. Take care that the
knife-edge contacts of the connecting plug are of different widths.

Never attempt to forcibly replace the connecting
plug (+ and -) by pressing on the bushes. The bush-
es would be irreparably destroyed and they would
have to be renewed.

b) Serial RS-232 interface
The 'OUTPUT' bush is the serial RS-232 interface in 3.5 mm stereo
jack format. The occupancy is established as follows (view of plug).

The ground ( = GND = reference magnitude or potential) is at the
back of the plug.

The RX contact (= 5 V high imput = data imput) is located at the
plug's centre.

The TX contact is located in front at the tip ( = 5 V high output =
data output).

First of all, before communication between the thermometer and
an IBM-compatible PC can take place the conditions must be set
up:
A connection between PC and thermometer, and the installation of
the software.