Perfectpro Bathroom Radio, Black RB1 Hoja De Datos

Before plugging the AC power cord into the AC socket, be sure the voltage is correct. 

If you have batteries in the radio and using the AC power supply, the batteries will 

automatically be disconnect.

AC power cord storage is designed to store the cord when the radio is not in use.

Note: In order to disconnect the unit from the mains completely, the AC plug should be 

removed from the mains socket completely.

1.  To open the battery compartment, first turn the battery cover fixtures anti-clockwise

 

to loosen and pull down the battery cover.

2.  Insert 6 x C size (UM-2) battery with the correct polarity into the compartment. Close 

the battery cover and fasten the fixtures by turning clockwise. Close well to prevent

 

moist or dust from entering the compartment.

3.  If the unit is not to be used for any extended period of time, it is recommended that  

 

the batteries are removed from the radio.

The approximate power level of the batteries is displayed in the LCD display of the radio. 

When the power level is very low the indication “Battery Low!” appears and the battery 

symbol flashes on the display. The batteries should then be replaced soon to continue

normal operation of the radio. 

Danger of explosion if battery is incorrectly replaced. Replace only with the same or 

equivalent type.

Do not expose the batteries to excessive heat such as sunshine, fire or the like.

Batteries should not be disposed of by incineration and with household waste. 

Disposable batteries should be taken to a suitable recycling centre if possible.

  

1.  Place the radio on a flat surface.

2.  Carefully extend the antenna located on the top of the radio. Adjust the antenna so  

 

it is vertically extending above the radio.

3.  Plugging the AC power cord into the AC socket. The radio will start up and the  

 

display will show “WELCOME TO DIGITAL RADIO” for a few seconds. Then the  

 

radio will automatically perform an auto scan of the Band III DAB channels and the  

 

FM band, the display will show “ATS setting”.

4.  When the scan is completed, the 10 strongest FM stations will be stored as presets.  

 

The radio will switch to standby with the updated clock and date showing on the  

 display.

5.  If no signals are found, the clock will not be updated. It may be necessary to   

 

relocate the radio to a position giving better reception. 

You can use this as an alternative antenna for your radio in areas or locations where the 

radio-signal (FM/DAB/DAB+) is weak to very weak.

Installing: Carefully screw off the standard flexible antenna. First carefully loosen the

antenna with an open-end-wrench (size 14) – turn counter clockwise. 

Carefully screw on the metal telescopic antenna and softly tighten it with an open-end-

wrench key (size 14) – turn clockwise

G B